2. analog
  3. 1232167208

How will XLR cables vs RCA effect a phono pre

I have an TNT V with SME IV type 6 tonearm with a Sumiko Sho cartridge that is a high output at 47K ohms and the output voltage is 2.3 mV. I have had to move my turntable so the cable going to ARPH3SE is one meter, but the cable going to Krell Pre-Amp needs to be 2m. If I were to upgrade to another phono pre-amp, would I be better off looking for one with XLR connections? I notice that there are not a lot of phono-pre that have XLR. Why is this? Would I be better off with a battery pre that seems to be very quiet or bite the bullet and look at BAT or similar? Can someone explain the difference between using RCA or XLR cables on a turntable and phono pre-amp? Any help greatly appreciated.
adorfman
tpsonic
1,092 posts
 
I have configured my table to run balanced,to take full advantage of the Aqvox phonostage.All that is need is to parallel the arm-ground to be used as the "ground" on each XLR.The cartridge is naturally "balanced",the "+" being non-inverted and the "-" being inverted.
atmasphere's avatar
atmasphere
11,861 posts
 
Using a phono cartridge as a balanced source is something that was first done by Atma-Sphere, in 1989 with the MP-1 preamplifier, which also has a fully differential phono section.

You do *not* get more gain with the cable- you get less noise, and less artifact from the cable itself.
Ag insider logo xs@2x
rauliruegas
13,101 posts
 
Dear Adorfman: As Atmasphere point out there is no more gain ( you have more gain only when your IC balanced connections goes from preamp to ampliifer ) but less noise/distortion ( between other things ).

Now if you are thinking on a phono stage change IMHO it will be a good time to eliminate those IC ( cables ) that makes a cartridge signal degradation and buy a fully balanced active gain Phonolinepreamp ( integral unit ).

Regards and enjoy the music.
Raul.
curio's avatar
curio
305 posts
 
The XLR will give you 6db of additional gain and is theoretically more quiet..

I confirm .. not theoretically!
I used RCA cables between my Whest Audio 30RDT and the Pass X1 preamp and lately the same cable but Balanced and now I have more audible gain (4db not 6)and more quiet or better less audible blow from the tweeter even if the 30RDT is silent like a fish also by RCA
stringreen's avatar
stringreen
6,475 posts
 
..I understand the quality of difference between balanced and single ended has lots to do with how the circuit was designed. Some circuits that are designed single ended, probably wouldn't benefit much from a balanced connection. Those circuits that are designed for balanced benefits much more for using xlr cables. I have an all Ayre system, and each of those components sound quite a bit better balanced than in single ended mode.
More to discover