Sota Reflex Clamp Loses Contact with Record


I've got a reflex clamp that I use on my Star Sapphire. I've notices a couple of times that if I simply lay the clamp on the record and push the lever down that the action of the clamping pushes the clamp up, leaving a gap between it and the record. I imagine that doesn't make the clamp very effective. If I apply a little pressure when I'm locking it down then it stays where it's supposed to, but this leaves me concerned about stressing the suspension.

Anyone else experience this and have any thoughts?

Anyone have any thoughts on this?
grimace
I have a new NOVA. I've owned two Star Sapphires. It has not been my experience that with the vacuum the lp falls away from the Reflex Clamp because I have always clamped the Clamp down. Although weighty and given the great vacuum suction the clamp likely does positively impact matters if it is simply at rest atop the disc, it is a simple matter to clamp it down as it is designed to do.

The need for simply placing an object beneath the center of the table for eliminating stress on the suspension springs seems a minor matter given the high quality-for-the-money SOTA tables.

Heck, on A'Gon I wouldn't be too surprised to find someone selling an expensive wooden block for the purpose.
I have used the SOTA clamp with a number of different tts, starting with a SOTA Star Sapphire. A few years ago, I noticed the very same problem to which you refer. As others mentioned, I found that by applying some downward pressure while activating the clamp mechanism, the device SEEMS to be making good contact with the LP label. It still bothers me a bit, because the thing is useless if it is suspended in air over the LP. As a result, I very often just place the clamp over the spindle without clamping it down, particularly with my idler-drive tt, where clamping to the spindle could have a down side (transmission of vibration directly to the LP).
I just hold the suspension with my fingers forming a clamp with my thumb below table and my fingers holding the top so the springs dont really move when I push the clamp down onto album, I never placed anything under it and never bottomed anything out.
My friend has the Nova table and will only use his clamp with warped albums because his Clearaudio cart hits the clamp before the run out groove on most albums.
Take a look at a Bren1 record clamp sold here on Agon, Amazon and Ebay.
I manufacture them and have sold to many happy Sota users.