The correct internal-inductance of Windfeld cart.?

That sounds so impossibly high that I agree it MUST be an error. There's just not enough wire in there to generate that much inductance. I will bet that they meant to write "micro-" Henries, not "milli-". Even that much seems a tad high. Of course, I am only guessing.

Dear Axelwahl: I don't know to what brochure you are reffering but here you can read that >10 ohms:
http://www.ortofon.com/index.php?option=com_content&view=article&id=230&Itemid=225

I don't know too why is so important to you the internal-inductance but you can ask directly to Ortofon here:
http://www.ortofon.com/index.php

Regards and enjoy the music.
Raul.

According to the Ortofon specification sheet, the PW has an internal resistance of 4 ohms, and an output of .3mV. If you are trying to work out what kind of step up transformer will work for this cartridge, those numbers are what you need. These are pretty much normal numbers for a relatively low output cartridge.

As for the inductance, I have no idea. Why would you need to know the inductance? I would assume that the PW is like any other MC cartridge, which means an insensitivity to capacitance loading.

Thanks for the help, why I asked for the correct impedance?
To determine the bandwidth of my system after SUT loading!
f/3dB = R / 2pi*L ...that's why :-)

Got it right now by primary loading 13ohm! Fidelity Research XF-1 type M (1:31.6 ratio) ergo 47ohm natural impedance with 47k phono-pre input impedance. (47k/31.6^2 = 47ohm)

So, 13*47/(13+47) = 10.18 ohm primary input impedance to match PW >10ohm recommended impedance.

The brochure I was referring to is the very one THAT CAME WITH THE CART! Mr. Rauliruegas
(Ortofon do know about their miss-prints, why ask?)

Meanwhile NOBODY at Ortofon commits to a correct impedance figure, other then 10 - 100uH -- Not so professional I say --- the reason? "We don't measure it..." well, well, well