Finding the correct size DIN for tonearm is not easy. Many at Radio Shack look like the right size but don't fit.
If you're not using the tonearm I would cut one end off a super cheap RCA / RCA, maybe one of those that came with a Direct TV box or VCR and solder alligators on one end.
Clip the alligators on the cartridge connectors of your tonearm (without the cartridge !!), plug the remaining RCA end into a CD or DVD player and terminate the tonearm plus new phono cable into a high level input of your preamp and play music.
You can actually listen this way to confirm signal is working on both channels. I did this for my new tonearm + tone arm cable and saved many hours of LP playing to achieve break in. CD is faster and better than a cartridge too, about 1 volt where moving coil cartridge could be .2
I was waiting for service on my turntable so I burned about 900 hours on mine. You would probably get most of what it's going to do in much less time.
To answer your question:
Yes it matters which you use, the four pins on DIN are plus and minus left and right channel plus ground. I can measure the custom one I have to give you pin out but the alligator clip is better as it does the tonearm at the same time.
If you're not using the tonearm I would cut one end off a super cheap RCA / RCA, maybe one of those that came with a Direct TV box or VCR and solder alligators on one end.
Clip the alligators on the cartridge connectors of your tonearm (without the cartridge !!), plug the remaining RCA end into a CD or DVD player and terminate the tonearm plus new phono cable into a high level input of your preamp and play music.
You can actually listen this way to confirm signal is working on both channels. I did this for my new tonearm + tone arm cable and saved many hours of LP playing to achieve break in. CD is faster and better than a cartridge too, about 1 volt where moving coil cartridge could be .2
I was waiting for service on my turntable so I burned about 900 hours on mine. You would probably get most of what it's going to do in much less time.
To answer your question:
So, I would need an inexpensive cable that terminates at one end in a pair of male RCAs. I can cut-off the other end (whatever it is) and solder on a male 5 pin DIN.
Does it matter which of the 5 pins on the DIN are soldered to which wire coming from the RCAs? Most "zip cord" has just two wires, so I would be soldering at two of the five pins.
Yes it matters which you use, the four pins on DIN are plus and minus left and right channel plus ground. I can measure the custom one I have to give you pin out but the alligator clip is better as it does the tonearm at the same time.