Thorens TP-16 Tonearm cartridge mounting issue


Recently, I have acquired a Thorens TD-160 MKI equipped with the original TP-16 tonearm and headshell. I am using Dynavector 10x5 and Grado Gold cartridges but would like to try a Reference Grado in the near future. The problem lies within the headshell of the TP-16 tonearm, as it only allows for mounting from underneath the headshell and there are no holes on the top. After close examination, it seems I can remove the lid of the headshell but there remains a top that lies just above the threaded cartridge plate. Ideally, I would like to have 2 slots located above the headshell plate for cartridge installation and adjustment, this would make installation for Grado Reference and other cartridges much easier.

Does anyone know if there are other headshells that I could fit directly on the end of a TP16 with open slots on the top? Maybe a MKII headshell would work but I am really not sure?

Here is a link to a picture of a TP16 tonearm-
http://www.vinylengine.com/library/thorens/tp16.shtml

Thanks to everyone for your input.

Cheers,
Chris
chris74
Found a formula for calculating compliance here -

http://www.theanalogdept.com/cartridge___arm_matching.htm

This really helps!
The cheaper Benz Micro cartridges,Benz Micro MC20E2-H MC20E2 High Output Moving Coil or the Benz Micro MC20E2-L MC20E2 Low Output Moving Coil cartridge seem to be a good match for your Thorens arm at around 10.9Hz,if you need a suggestion.Both are available from LP Gear.
Does anyone by chance know if the TD166 motor is the same motor that is used in the TD160 MKI? I am searching for a spare and found one from a TD166 but am not sure if this is the same 16 pole asynchronous motor as used in the 160.
Chris74 ; Check with www.theanalogdept.com they have a Thorens dept and are usually available for technical questions pertaining to Thorens Vintage...You also could check with www.vinylnirvana.com he does upgrade and custom work to Vintage Thorens tables