Dynavector 20XL

I just wanted to thank everyone for their input and sharing of their vast knowledge on this matter.

I will keep you posted as to what I find after I implement the recommended adjustments and tests.

Thanks again.

Nobody mentioned that the cause might actually be static. When I started up with vinyl after many years away from it, I had some huge issues with static during certain dry periods. You might try some Gruv-glide to see if static is causing your problem.

Static might be the issue, though discharges are usually intermittent. A constant "static-type noise" is rarely caused by that.

I wouldn't recommend Gruv-Glide without noting that it leaves a residue in the grooves, a residue which many find sonically undesirable. It's not clear from your post that static was actually your problem. Uncleaned biologicals in the grooves is a more likely explanation, especially if these records weren't cleaned with an enzyme-based solution. The Gruv Glide may have just covered up the problem. It's one of several record care products that behave that way, none of which will ever be used on my vinyl.

A safer way to test the static discharge theory would be to zap the suspect LP before/during play with a Zerostat.

I spent several hours realigning my cartridge so that is was exactly the way VPI specified for the Dyno.

It has made a huge difference, with the end result being that it is now on the bright side with very minimal "static" harshness.

I did notice that it was more pronounced in 120g older vinyl than on the new 180g records.

tonight I noticed that there is "distortion" coming from my 20xl during loud passages when it gets close to the end of the record. It seems find at the beginning of the record, could it be tracking error?