2. analog
  3. 1246763384

SDS Power cord

Using an SDS on a Scoutmaster Sig TT. Was considering replacing the cord that runs from the TT to the SDS, but a unique rectangular opening on the case of the SDS prevents any of my existing PC's from allowing the plug contacts to make a full connection.

To those that may have done this, any suggestions on a PC cord that would work?
terra3
cerrot's avatar
cerrot
1,700 posts
 
I had a few shunyata diamondbacks lying around, so installed them into the sds/motor - nice difference. I think any power cables near cartridge/phono stage should be shielded-and decent. I wouldn't get pythons for it but do see (hear) improvement over stock.
kenk168
175 posts
 
If you don't want to spend a lot of dough, the Iego PCs available here on Agon is much better than the low price indicates. Read up on it and find out. I have a handful of their cables in my system and found them to be well worth the investment.

Kenobi
flyfish2002's avatar
flyfish2002
94 posts
 
I had a local tech wunderkid move the female outlet that the motor PC plugs into on the back of the SDS flush with the rear chassis wall - cost me a beer. I then bought a VH Audio Flavor 1 to replace the stock VPI cord. Was it worth a bit north of $200 - in my system, yes. The Flavor 1 is a fully shield, true hi-end PC at an unbelievable price. It took that last bit of background noise out.

What is DEFINITELY worth it is using a high quality PC to power the SDS - don't skimp. I use a VH Audio Flavor 4.

If you care, my system is not listed on AudioGon, but it is listed on Audio Asylum.
More to discover