Dynavector XV1-S and step-up

Lewm: yes, original post talked about the MC a little, so thought I'd framed it properly - looking to optimize, not reinvent. Question is whether it's optimized for the Dynavector, hence the discussion and desire to see whether an SUT into the MM (this pre has both) might be interesting. Thanks for your input. I have a few paths to explore based on this post and some constructive private thoughts.

Axel, I accept what you are saying about the differences in optimal input impedance when using an SUT as good technical background. I gather the manufacturer's specified 30 Ohm minimum loading is intended to apply to a normal MC gain stage and not an SUT and that optimal SUT loading may well be a value substantially lower than 30 Ohms.

There's no need to act so exasperated or put upon in communicating your technical advice. If it's that much bother, perhaps you should just return to listening to music and let the rest of us wallow in our ill-informed state.

Dear Hatari: IMHO you own a very good analog rig with that Raven/Phantom/XV-1s combination along your Sarastro IIs.

IMHO too, before to think in an external step-up that always makes a cartridge signal degradation and that ( with all respect ) does not make sense to me on your audio system maybe is time to think in a way better quality performance phono stage that can do justice to that top front end.

Through your Masseto there is no single opportunity that you can hear what the XV-1s can show when it is mated with a phono stage at the same quality level that the Dyna cartridge.

If I was you and if I want to improve the analog quality performance of that audio system my very first step will be to " disappear "/change that " poor " phono stage that IMHO is at very lower level than the rest of the other system links.

Regards and enjoy the music,
Raul.

Raul, thanks (I think). Just for fun, what phono stages are at the higher level to allow me to improve my "poor" phono in the Masetto. I'm honestly dying to know, as I'm very impressed with this phono. Perhaps it's a typo but you say "IMHO too" - no one else on the forum has suggested similar... Let's say the bogey is $5k - what do you suggest?

Look forward to hearing your specific thoughts.

Regards

Hatari, You are hearing the opinions of two very knowledgable persons (Axel and Raul), who have their own private biases based on their own past experiences. There are lots of equally knowledgable vinyl fans who would disagree with Axel on loading with a SUT and with Raul who just does not like SUTs. I tend to agree with Raul, but you should form your own opinion, and one way to start is by listening to the preamp you already own.