Spacer between cartridge and headshell on Breuer

Hi, Clabe--

I can't imagine Jeff at Highwater couldn't solve this for you. Give him a call!

i recently installed a breuer 8c on my micro seiki rx1500, i needed more height actually and installed a 1/2" spacer under the arm base to raise it up at the back end. however, in your case, there should be lots of space to lower the arm. did you loosen the arm cueing mechanism? that will definitely have an effect on how the arm sits. it slides up and down around the mounting base to accommodate the various heights of the arm. to answer your spacer question, my arm did not come with any spacers, so i don't think that it's a breuer part.
don

HI Clabe

I have seen a guy use a spacer on his Breuer for that reason, and it came from Graham Engineering, same shape as the Phantom headshell, but it looked ok in the pictures. That would be your easy solution.

Your other option, and Jeff from High Water Sound says he has almost the same problem with is Breuer on the Raven One/Two is that with that arm cart and table combo the spacer for the armboard is a touch to thick so he cannot get the back of the arm down as much as he likes to get a full VTA range of motion if your cart is not too tall.
So if your dealer can have Thomas from TW can make a thinner spacer to put under your armboard, that would solve you problem, or get the new VTA armboard which looks very slick in execution and provides VTA on the fly without compromizing ridgitity.

Hi Pcosta!
You´re an angel, got the message right on spot.
Getting thinner spacer on armboard for Raven One will solve the problem.
Dealer told Thomas to send one.
I wish it was the armboard with VTA on the fly but it cost more than 1000 euro (smart and quick testing different carts).
I´m also waiting for my Mint Protractor.
BTW, instruktions for Breuer was printed on bottom half of a single sheet of paper and no protractor. Not much considering price.
What about antiskating, is there any at all.

Many thanks for taking your time, and the rest of you!

You could also try a copper mat effectively raising the height of the LP same as lowering the height of the cartridge with spacer. The Raven One spindle isn't very long though so you might run out of room with mat + LP + clamp.