2. speakers
  3. 1403935250

REL Magic

I have to report this finding as a breakthrough to a new plateau. For the past four years, I have been running two REL Strata III's, one behind each Maggie 3.6R. RELs have always been known for their hook up at the speaker outputs. By this method of integration, REL boasts that their subs somehow lift the entire system. I have always felt this to be true, especially with one for each amp.
But now, I have just completed DIY signal cables for each sub using the same Neutrik connectors into the subs. I used some 16-gauge OCC copper wire by Furutech in the same terminal scheme as the stock cords. As expected, the bass notes are more extended and better defined, but this phenomenon of improving the whole presentation has also appeared again as even more impressive. Everything across the soundscape is just a bit more sweet and clear. If you have not upgraded your REL signal cables, please do.
128x128jafreeman
jafreeman's avatar
jafreeman OP
689 posts
 
Thanks for the reminder on the fuses, NMman--I will replace the stock fuses.
sunnyboy1956's avatar
sunnyboy1956
424 posts
 
Nmmusicman
Thanks for the insight. Can the REL cable be ordered online and what is the value\rating of the fuses ? Tried to check the fuses in my G1 but the font is way too small to read.
Pradeep
nmmusicman
276 posts
 
Sunnyboy, the mains fuse for the G1 are 5 Amp semi delay(slo-blo) 230 volts, 10 Amp semi delay(slo-blo) 115 volts.
Yes the Bassline cable can be ordered on-line, Music Direct has them. Also, not sure about the G1 but my Stadium lll also has two fuses inside on the amplifier PCB as well as the mains fuse. I changed all three.
sunnyboy1956's avatar
sunnyboy1956
424 posts
 
Nmmusicman
Many thanks. Found the MD link. Checking with the local REL dealer if can order the baseline .
Hopefully should acquire the SR fuses.
Cheers
sabai
2,027 posts
 
Jafreeman,

I have to thank you for this information. I had some Furutech FS Alpha speaker wire in the closet terminated with Furutech rhodium spades. I made the connection you suggested by splicing the Furutech onto then ends of Synergistic Research REL cables -- and then making the Furutech connection into my power amp. You are absolutely right. Not only does the bass sound better but the whole sound stage is improved with improved detail, as well. This is actually like an upgrade. I am very happily surprised. Thanks again.
More to discover