2nd tonearm on HRX

Dear Marco, I ordered such an 'construction' for my Kuzma Stabi Ref. by Reed L (www.turntables.lt).I.e. a tonarmbase
and an 12" tonearm. The possibility in your case is dependent on the dimensions of your VPI. You can email me
for the detais.

Regards,

I've actually thought about adding an extra arm to my TNT by drilling the requisite hole in the left rear corner - ie a direct mount to the plinth.
It looks like the TNT would have the 'real estate' to accommodate an extra arm, but i'm not sure if there would be any negative ramifications (ie possible damaging vibration etc) by doing this.

Paul, go for it.

My HRX had the JMW tonearm hard bolted direct into the plinth, so doing the same on the other side should have no sonic impact.

Hi Downunder, the HRX plinth is a sanwich of acrylic-aluminium-acrylic, do you think it's possible to drill holes without damaging it?
More precisely, I would need to drill holes on the acrylic in order to bolt an armboard to the aluminium center layer, do you think that's doable?

Dear Marco: Looking in your virtual system I'm not sure even how you can accomodate a stand alone arm board in the rack/platform. About that the arm board has to be connected to the plynth maybe in theory but there are many such set up working just fine ( I have one of that set up running very good. )

Anyway and this is not what you are asking but maybe is time that you could think in a TT change where you can buy/have a " natural " TT that handle/mount several tonearms at the same time, there are some very good choices out there where I'm sure you don't have to " sacrifice " nothing on quality performance for what you have today ( VPI ).

Regards and enjoy the music,
Raul.

Regards and enjoy the music,
Raul.