2. analog
  3. 1258588290

Getting The Most Out Of My Scout

Hi Folks:

For a variety of reasons I've decided, for now, to keep my VPI Scout and upgrade my cartridge from a Dynavector 20XM to a Dynavector XX2MKII. Before my cartridge arrives and I make the change I'd like to make sure I'm getting the most possible performance out of my Scout. I am aware of the following upgrades that are available through VPI:

300 RPM Motor (I have this already)
Super Platter and Bearing
HRX Mini Feet
JMW9T Arm (with Nordost wiring?)
Stainless Steel Clamp
SDS Speed Control

Are there any I am forgetting?

Here is my question: Which of the available upgrades will provide the biggest performance improvement? If anyone cares to rank order the upgrade options that would be great.

Final question: I am interested in using a better set up jig (better than the stock one from VPI) when I install the new Dyna XX2MKII. Which of those available allow the best cartridge alignment for this table? I've seen a few out there but cannot tell which would be the best to use.

Thanks for your help!
128x128dodgealum
narrod
1,064 posts
 
MarkD51 said,

"make the Scout sound like a $44 plastic garrard table from the 70's."

Hyperbole is fine but this is a silly statement. :-)
markus1299
252 posts
 
A few years back, my entry level TT was the Scout. Out of the box, it was a little flat but after much tweeking the sound to my ears was great. I used the Mint tractor which really made a big difference and also the Cloud 10 isolation platform which took it up anothet level. After that, I went up the Ortofon cart line and found that the P Winfield cart absolutely opened this table up. I have since sold the Scout but still have the Cloud 10 isolation platform if you are interested

Good luck
Mark
nolitan
865 posts
 
The scout is a great TT.
Years back i had them on Ultra Symposium-makes a huge discernible difference.
The Mint LP protractor is also very good. The difference is the quiteness of the sound as well as the free flowing sense of musicality.
I would highly recommend the MINT LP as well.
maczurak
28 posts
 
You have the Scout on a wall shelf mounted to the upper portion of your cabinet. Have you tried placing TT on a solid table somewhere else in your room? I wonder if this might allow you to gain some additional performace from what you already have.

I have completed the following for my stock Scout:

- 300 RPM Motor
- Signature Tonearm
- Super Platter
- ring clamp
- silk thread belt drive
- PS Audio P300 (speed regulation)
- ZYX Fuji cart

I use a solid oak end table having spikes on the legs for isolation and leveling. The table is mass loaded with LPs. A solid maple block has been placed on the table and isolated using some Sorbothane pucks I had laying around. The motor sits on a piece of slate isolated by smaller pieces of Sorbothane I cut from a sheet purchased some time ago.

This performs way better than anticipated so the only thing I will do in the near future is to the get an SDS one day. I think the best thing I did was to place the TT on the end table and add the maple block.

Another TT will be several years down the road as there is no hurry at the moment.
cmalak
681 posts
 
Dodgealum...have you received your Dyna XX2MkII cart? What tweaks/upgrades to the Scout did you end up doing? What's the sound like compared to your prior setup with the Dyna 20X cart? Thx
More to discover