MG-1 airbearing arm tracking problems?

not necessarily specific to MG-1 but general about most airbearing arms * levelness is a must. Not table but arm. Should be the same but often isnt. * VTF---Too iight will cause tracking issues. * wire impact on tonearm---Get the wire in a bind

You should contact Ada Lin direct. He is very helpful with the setting up of the MG1.

Regards

BrianC

Thanks for the advice. Much better now after very careful levelling etc. Th final solution was removing the Isolator though, along with the blob of blutack necessary on the counterweight for the added weight. Why should this be?

I emailed Ada, but received no reply

Too bad Ada didn't get back to you. He has been very helpful to me; he does get busy at times, but usually isn't too hard to get a hold of.

Have you done any fluid damping?

Whats the update?

I'm considering one of these arms. I've been reading old posts on here... back when he sold it for $299... is it still made of plastic?
This seems too good to be true... which means somethings up.
He is apparently afraid of a real review... he should send one of these to get reviewed so that we could read an impartial review...his opinion may be 'partial'.