SME V or Graham 2.2 on Michell Gyro SE

Either arm will work fine on the table. Its an entirely different matter as to what cartridges work with those arms, and that issue is far more important.

Stan hjas been arround block but also think Atmasphere has a good point about Cart/Arm compliance.
Chazz

Something tells me Atmosphere has been around a few blocks himself. :-) I would assume Ssayeed is going to use his current Benz M2. If that is the case both arms should work well. I've not owned the SME, but I found the 2.2 not as enjoyable with low compliance cartridges. And it is somewhat finicky to setup with regards to the damping fluid.

Thanks for the responses. Yes, I am going to use the Benz M2 on the new arm. I am planning on keeping the Techoarm and have a Ortofon Rondo Red on it at the moment. So the SME or Graham will be an additional arm on the table.

Since the mass of both arms is in the medium range very low compliance cartridges are not ideal for either. I never meant to imply that they are identical in sound, only that they are of comparable quality. Which is best with a particular cartridge would be a case by case question, both work well with the medium compliance MCs [Denon 304, AT OC9, AT 33EV] that I use. I find the Graham alignment system easier for my old eyes than the SME but the SME system is also extremely accurate if used properly. I have found all arms that use damping to be a little finicky, I ended up not using it at all on the SME IV and VPI 12.7 as the cartridges I use do not require it. I use about the minimum amount in the 2.2. I will probably do the same with my Jelco 750, which I haven't yet set up, haven't got all the parts for my Linn upgrade project yet.