Anyone using a Lyra Delos yet?

Did he write about the dance ability? No? Here you see the right position for it.

Jaspert: if you think there is a problem, put the cartridge back into the box, put in a label that says "low rider", and give it back to your dealer so that they can send it back to us.

We will be happy to take a look at it and address anything which may be amiss. My guess is that it's only an adjustment issue rather than involving any component failure (which I believe is true for most low-riding cartridges which are two years old or less and haven't been tracked over the manufacturer's VTF recommendations).

As an aside, one more thing that you may want to watch out for is whether your tonearm uses a damped elevator mechanism or not. If it doesn't, and "drops" the cartridge into the LP surface, the repeated impacts over time will stress and degrade the suspension. The suspensions of most non-DJ MC cartridges aren't designed to stand up to this kind of treatment.

hth, jonathan carr

Hi Jonathan,

Thanks for chipping in. I have contacted my dealer who will look into for me as it rides low from the word go with only a few hours on it at most.
The arms i have used are Phantom ii and a new Reed 2 both with damped lift mechanism so no DJ arms here.

It sounds really good but i do have issue with fluff ball accumulating on the paper towards the end of side at times impairing the performance. I think it's just a low rider needing adjustment.

Thanks,
jasper

Syntax, Great photo. But your SRA looks a bit off, based on Fremer's latest column in S'phile. 92 degrees, he says.

Not necessarily. Fremer defines the SRA as "the angle between the record surface and the vertical axis of the stylus's CONTACT AREA area..." He then goes on to say that "to properly set SRA you need to know the stylus profile contact patch of your catridge." If a cartridge has an "extreme-angle contact patch" (like the Ortofon A90), it would require that the shank of the stylus "be actually pitched far forward for the contact area's SRA to be at 92 [degrees]." He also warns against using the shank of the stylus as a reference for setting the SRA.

I believe the Delos has a line-contact stylus, just like my Soundsmith Aida, and the shank of the stylus might have to be "pitched" forward to get 92 degreees, like Fremer says. The angle of the shank of my cart's stylus looks very much like Syntax's Delos'.

I won't deny that I find it rather confusing and have no idea how to verify it is in fact 92 degrees at this point. It seems you have to use a microscope and software like Fremer did. Perhaps Mr. Carr can express his opinion on the subject.

I was wondering if anyone has had an opportunity to compare the Delos to the Benz Glider S. Thanks