check out the TransFI terminator linear tracking air bearing arm. Just google Transfi Terminator. Also a couple of good reviews here on Agon. It was a significant upgrade from the fully modded RB 300 i was using. It will fit your armboard.
Which tonearm?
I have a VPI Hw-19 Mk III with an armboard drilled for an RB300. I want to upgrade my tonearm but VPI hasn't written me back about armboards for the HW-19 and I really would rather not get another one. So if that's the case what tonearms can I get that would fit the armboard drilled for an RB300? I did read here that the JMW-9 has the same geometry but he had a Scout. Being a newbie, not sure if that applies to my turntable or not?
Another quick question. If I were to upgrade to the mk IV which has either a TNT platter or Scout platter, would I have to change to a thicker armboard because they're thicker platters? Thanks for your patience!
Another quick question. If I were to upgrade to the mk IV which has either a TNT platter or Scout platter, would I have to change to a thicker armboard because they're thicker platters? Thanks for your patience!
- ...
- 9 posts total
- 9 posts total