Turntable dust covers


Hey -

I don't post much but I have to plug JMK Displays (http://www.jmkdisplays.com/).

They do a bunch of acrylic/plastics work and I just got my dust cover for my brand new Clearaudio Concept. I'm stoked. Custom dimensions, custom cut-outs for cords in the rear of the cover, etc., 1/4" acrylic - looks SHARP! All for about a buck and a quarter. Can't beat 'em. Even the kids were impressed!

If I knew how to post a pic I would.

Check them out if you are in the market for a dust cover. BTW - I do not work for them.

Cheers,
PJ
pjasek
hello,

How were they at working with the custom cut outs? I have a VPI Aries the would need several holes for power cord, motor switch and ICs and I had problems getting another maker to "get" the dimensions and locations of cut outs.

Mike
I'm sure they are a better deal than the Ginko rip-off. However, I checked them out and they were not as good as a shop in OH. John (www.displaycasej.com) offered top customer service and the product was superb. And it was cheaper than jmkdisplays.
There is also a member here who offers custom covers. I will definitely be in the market for one, after I set up my new table....after I move to my house...and figure out how to...then figure out which arm to get...learn to set IT up...decide on which cartridge...try to set IT up...then which cable to get...figure out my best LP cleaning system....it wont be for a while, yet
Simple - you just send them a diagram with the cutouts and specs and they work off of that.
I just got one from JMK displays as well. I faxed them my rear cut-outs and recieved the product with the exact dimensions and cut-outs that I had requested. It is beautifully finshed and I am 100% happy with it.