Dynavector 20x2 High or Low Output?


I have a VPI HW-19v4 table with a 12.5 arm. I am currently using a Denon 103r with a Bob's Cinemag Step-up. I have a friend that is selling a like new 2.8mv 20X2 for $750. Should I hold out on a Low version since I have the Step-up or get the HO version and lose the Step-up? Has anyone A/B'd the Denon to the 20X2? Finally, what are your thoughts of this cartridge is it a worthy upgrade from the 103r?
128x128podolaw
What would your recommendation at $750-1k ?

Not sure what you are using for a phonostage but quite possibly you would be better of spending the bulk of the above total upgrading there and leave $250 or so for a good quality but not insanely priced LOMC. I think the law of diminishing returns applies more strongly to the cartridge rather than the phonostage and thus you may end up with better sound going in that direction than dumping the money on a very expensive cartridge. For example, my prior setup (Whest PS.30R and Dyna XX2MKII) was nowhere near as good as my current Herron VTPH-2 and AT OC9MKII and the OC9 I got for around $200. Just a thought.
Well, Herron would be way above $1k ,I guess, but generally I agree with this approach. Besides, most cartridges are very overpriced. I keep hearing praise about Herron.
Yes, Inna you are correct. My post wasn't clear--my point is that perhaps the OP's funds are better invested in the phonostage rather than a new cartridge. That the little OC9MLII run into the Herron outperforms the $2K Dyna into the Whest opened my eyes to the importance of the phonostage. Finding the right balance in terms of allocation of funds is key IMHO.