Cartridge for VPI Classic?


I just sold my VPI Scout to replace it with a VPI Classic.
My system is as follows :
Whest PS.30R Phono Amp
Musical Fidelity A5CR Pre Amp
2xMusical Fidelity A3CR Power Amps biamping
Proac D15
Nordost Red Dawn/SPM Interconnects/Speaker Cable (I may look to change these)

I like my system but I'm a bit disappointed with the slight harshness in the top end, especially in reproduction of sibilance which I would like a cartridge to handle well.

I'm considering the following:
Benz Glider SL
Benz Wood SL
Dynavector 17D3
Dynavector XX2 MKII
Soundsmith VPI Zephyr

Any others that I should consider?
Any advice/experiences?
ecosse_011172
With regard to interconnects: I purchased some 26 gauge, shielded, silver-coated copper teflon wire from John's Silver shop on Ebay (it was $15?) and some inexpensive solid copper RCA plugs (don't over pay for a big name. PartsconneXion is a good source.

If you have some patience and dexterity with stripping and soldering thin wire, this is a real bargain. They look ridiculously thin. However, they sound great. On the down side, if they don't meet your expectations, you are only out a few bucks. On the up side, they may fit the bill, and you have left over cash for something else.
@Jazzgene - Is this the regular Grado Statement or one of the 1.5mv versions VPI had made for them? I wish a Grado for my Scoutmaster but am a little conflicted as to whether I should get one of their regular low output models or one of those custom made for VPI (which are somewhere in between their high & low output cartridges).
But you do dial in gain, I guess the "VPI Grado's" are designed for less adjustable phonostages.
I purchased a Dynavector XX2 MKII for my VPI Classic several months ago, upgrading from a BenzMicro Glider .8 Mv cartridge. I haven't heard the Lyra Delos, but I would never say the Dynavector is veiled. It is VERY detailed and dynamic in my system, with voices and instruments sounding real and in the room. It's a very good match for the VPI 10.5 arm.