2. analog
  3. 1301702020

Which receiver for better sound with vinyl?

I have an old stereo system from the '70's: Nikko NR-515 stereo tuner/amp, Marantz TT 1060 turntable. I also just put together a new home theatre setup: big Samsung plasma TV, Denon 1910 avr receiver, and Jamo 606 5.1 speaker system with Jamo 250 sub. I'm trying to figure out if I'll get better sound for music (vinyl) with a phono preamp and hooking up my tt to my new denon receiver, or keeping the two systems separate. If I keep them separate and continue using my old stereo receiver with the tt, could I hook it up to my new Jamo speakers, since they have two sets of speaker clips on each speaker to permit bi-amping? Would my Jamo speakers likely sound good with vinyl? Obviously, I would only use one input at a time!
flowergarden129
flowergarden129 OP
5 posts
 
Schubert, do you think it could drive my Jamo speakers? Will I damage anything if I try it?
Post removed 
goofytwoshoes
15 posts
 
You can use the phono stage in your Nikko, connected to the Denon. With the turntable plugged in to the Nikko, and the Nikko's selector switch set to "Phono", connect from the Nikko's "Tape Record" or "Tape Out" RCA jacks to an unused input on the Denon. This bypasses the volume control of the Nikko. If you aren't sure that you like the resulting sound quality, disconnect the speakers from the Denon and connect them to the Nikko. If you still aren't happy with the sound, then perhaps a stand-alone phono pre is a good idea.
flowergarden129 OP
5 posts
 
Thanks, Elizabeth and Goofytwoshoes. You've both saved me time and money since I was about to either try connecting both receivers and/or ordering a preamp.
flowergarden129 OP
5 posts
 
Goofy,

I just tried running the Nikko to the Denon and it worked like a charm. The sound is still kind of muddy, but I'm going to start by buying a new cartridge and stylus, and see how that goes first. The one I have is ancient, probably not replaced since the early or mid-80's. Thanks for the help.
More to discover