I have a Clearaudio concept and I mounted a Ortofon 2MM black on it and it sounds good. Preliminary biggest fault is you have to be careful where you set it up because for traffic caused it to skip since there's only 1.5 g on the stylus.Fortunately right now my stand is sitting on a concrete floor so this isn't an issue at the present time, but if it were I would have to mounted to the wall or change tonearms which could be quite costly.The only other tonearm Clearaudio makes that I think would be safe on a wooden floor I believe would be the Universal Tonearm and that's pretty damn expensive And I don't know if you go to something like an SME tonearm.
As it is it sits on two forms of isolation products those half dome rubbery Isolators and they're sitting on a 2 inch maple platform which is the top of my stand and then again a 2 inch maple platform which turntable sits on and on top of that I'm using the Black Diamond Racing cones and pillows so I have plenty of isolation device.
I do have a couple of issues adjusting the Anti-skating and there's no way to put a Vertical Tracking Angle device on their with that tonearm and probably not This is enough room to install it.
I'm always open to suggestions!
George
