dynavector XX2MK2 set up question

i think because i am using Krell FPB600 above 100ohms is brighter, are you guys at 1000ohms using tube amps?Ack and Dan

I primarily run a VAC PA 35.35, an EL 34 push-pull amp. Sometimes, I switch to a Plinius SA 100 MKIII, 100wpc solid-state, depending on what I'm listening to at the time. I don't feel the need to change cartridge loading when I change amps. The Plinius has better bottom end, and is better for very dynamic material.

Best,
Dan

That makes sense, Dan. Loading has to do with what may or may not be happening in the specific phono stage in use, so I would not expect to change loading if the amp is swapped out. This is also why is doesn't really do any good to compare what loading someone else is using unless the comparison is done with same cart, tonearm wire and phono stage. Same with VTF. This will vary depending on what tonearm (and other things) is used with the cartridge.

No tubes spoken here. Take a look at the tnt audio review as well, also loading it with 1000ohms...

I liked mine best at 100 when using my Krell 650M amps and Thiel CS7.2s, and the same with my VTL tube amps and Harbeths. Two very different systems but the cartridge remained the same.