That makes sense, Dan. Loading has to do with what may or may not be happening in the specific phono stage in use, so I would not expect to change loading if the amp is swapped out. This is also why is doesn't really do any good to compare what loading someone else is using unless the comparison is done with same cart, tonearm wire and phono stage. Same with VTF. This will vary depending on what tonearm (and other things) is used with the cartridge.
dynavector XX2MK2 set up question
on vpi classic, do you set up with or without the mat on the table,
on without mat said 2.2g with the mat on it measure over 2.2 i think about 2.4g
and bass is too heavy, with the mat i set it 2.1g , bass is just nice , just right weight, play on 120 to 180g so far so good. any suggestion.
My phono on 40ohms. have not try moving higher yet.
on without mat said 2.2g with the mat on it measure over 2.2 i think about 2.4g
and bass is too heavy, with the mat i set it 2.1g , bass is just nice , just right weight, play on 120 to 180g so far so good. any suggestion.
My phono on 40ohms. have not try moving higher yet.
- ...
- 14 posts total
- 14 posts total