SAEC 308N vs 308SX

Dear Lew, I own the SEAC 407/23 for which it seems to be impossible to get the u. manual. So I made a copy of 308N from VE to get some idea about the construction. There is no mention of null points in this manual. For my 407/23
there are also all kinds of 'suggestions' reg. the null points but nobody knows for sure. According to some former Australian importer of the SEAC brand the sufix '23' means Baerwald but this was dismissed by others as a myth. It is
very strange that there are so many indistinc opinions about SEAC geometry.BTW I assume that you know that there are two versions of the 308; the sufix 'N' refers to 'new'.

Regards,

Dear Nandric, thanks for your insights. Please do note however the title of this thread, which is to say that I do know about the SX and N versions, but I want to know what differentiates one from the other, especially since the SX is now valued at about double that of the N version. By all accounts and from all information available on the internet (which isn't much), the SX version came after the N version, so I don't know why N would stand for "new", but it might have been new with respect to some preceding design.

The correct geometry should not be so much of a mystery. One could measure the offset angle of the headshell, and combining that information with the null points (given on VE), one can quickly say that the data do or do not conform to Baerwald or more likely Stevenson. (From all the other posts, it seems almost a sure thing that this tonearm was not designed for Baerwald.) I guess I will look at those numbers first. As I noted above, I have an armboard designed specifically for this tonearm, so I am probably going to be OK even if ignorant.

Dear Nandric: 407/23 effective length 233mm and 12mm overhang according SAEC. The 308 has different values, I think ???.

regards and enjoy the music,
R.

Yes, Raul. You were correct earlier when you mentioned that the 407 (at 9 inches) is a bit shorter than the 308 (at about 9.5 inches).

Tonight I had a chance to go poking around on Vinyl Engine for more info on these two tonearms,
(1) It appears that Nicola may be correct; the "N" may stand for "NEW". On VE, there is a reprint of the brochure for 308NEW.
(2) The 308SX is shown with the ceramic headshell; the 308N does not have the ceramic headshell. So that was one difference. The SX version has larger heavier "ears" flanking the bearing housing, to increase lateral effective mass. The arm tube of the SX might or might not be different from the N.
(3) The P2S distance for the N and probably for the SX is given as 235mm. Only 5mm of stylus overhang is recommended, for an effective length of 240mm. With a headshell offset angle of only 12 degrees, this results in an inner null point of 39.2mm (!) and an outer null point of 60.6mm. The ad copy says no tracing distortion on innermost grooves. I can believe that, since at 39.2mm from the spindle, the stylus is at best reaching the run-out grooves if not only the outer edge of the label. At 60.6mm it would probably be within the innermost cut of the LP. So they compromised the tracking angle over the whole rest of the LP in order to minimize tracking angle error in the innermost grooves. In contrast, Stevenson results in null points at ~60mm and ~117mm. And Baerwald and Lofgren B both have their null points farther away from the spindle than Stevenson. So the SAEC geometry is strange, indeed. Why choose to set your tonearm up so that only one null point occurs where there is music? Dunno. For one thing, the small headshell offset angle would tend to reduce skating force.