2. analog
  3. 1322427785

How a nickel can make a valuable improvement

I have a very slight out of level floor. When I replaced my VPI feet with the Eden Sound Bear Paws the right side of my Super Scoutmaster needed to be raised very slightly to be dead on level while keeping the Bear Paws tight to the bottom of the table. I used a nickel coin under each brass point on the right side of the table. This levelled it out perfectly and worked like a charm! The table sits solid and turntable and platter are exactly level for better focus and soundstage.
hiendmuse
brf
1,715 posts
 
I agree with Markpoa, use brass fender washers between the the feet and the plinth.
hiendmuse OP
257 posts
 
I would prefer to use brass, but doesn't that washer type have a hole in the center? I need to have a flat solid spacer the same thickness as a nickel so the spiked end can rest in the middle.
rcprince
3,068 posts
 
Hiendmuse, I think Markpao and Brf meant to put the washers beyween the turntable and the paws, i.e., slip it over the threaded screw and have it rest on the top of the bear paw that goes against the underside of your TT. That way the paws can still be tight against the TT, but with the washer in between.
markpao
519 posts
 
Yes, that is correct.
hiendmuse OP
257 posts
 
That's a great suggestion! I'll look into getting brass washers. Thank you.
More to discover