How a nickel can make a valuable improvement


I have a very slight out of level floor. When I replaced my VPI feet with the Eden Sound Bear Paws the right side of my Super Scoutmaster needed to be raised very slightly to be dead on level while keeping the Bear Paws tight to the bottom of the table. I used a nickel coin under each brass point on the right side of the table. This levelled it out perfectly and worked like a charm! The table sits solid and turntable and platter are exactly level for better focus and soundstage.
hiendmuse
I just got Bearpaws and I have not been able to level my table without using some playing cards under the feet. They are threaded but Stringreen made a comment above that implies if I need to do this (as I did with my VPI mini feet previously) I'm not adjusting the paws correctly. If this is the case I would appreciate either him, or anybody else, to comment on what I should be doing differently.
The Bearpaws should all be screwed tight up against the bottom of the table. See which foot/feet need a shim- I used a nickel under each footer only on the right side of the table to eliminate movement and bring table to level. Try a dime under each foot if a nickel is too thick. Use a good level to check for exact level front to back and side to side.
Sberger...My Bearpaws came with threads, and also with threaded brass washers. I threaded two of the threaded washers between the Bearpaws themselves and and the bottom of the turntable. I leveled the turntable exactly using a carpenters level by rotating the Bearpaw which raised/lowered them on their threads, then tightened one of the brass washers against the turntable, and then tightened one of the brass washers against the Bearpaw. This provides a very tight connection and a spectacular upgrade.
String,

I got the Big Fat VPI Paws. Each one of these comes with a locknut that allows for height adjustment at the bottom. Only one washer between locknut and main body of Paw. No washer for the top of the Paw to tighten against the table. So essentially can't raise lower Paws between them and table without them not being tight against plinth. So do you think I should ask for an additional set of brass washers?