Turntable speed accuracy

Thanks, Dev. I was just joking, but your post does move me closer to getting a timeline just to satisfy my curiosity.

And when I'm unhappy with the results (I pessimistically predict), I'll wish I had Lewm's skills or at least easy access to someone with similar skills.

Lewm, The Artemis is an interesting design. I have not heard one yet.

I had hum caused by the motor on a VPI Classic and a LP12. The Classic's motor is on the front left. Maybe if the motor was placed in the rear it would have been better. The LP12 had the motor and power supply under the platter. Could be if I had an outboard PS like a Lingo it would solve the hum. I was not using a Grado. I am sure there are TT designs that have the motor close that don't have hum issues. Just a matter of being well designed.

I have a SP10 mk2a now and experience no hum with the same carts. Sorry if all of this is off the topic of this thread.

Sarcher30: "Unfortunately bringing the motor closer to the platter also brings it closer to the cartridge as well. Which on the TT's I have had with that arrangement caused hum on most of my cartrides. There may be some TT's that sheild the motor well enough to pull it off."

Perhaps you can try grounding the motor housing?

_______

Lew, are you saying that you was able to get the Lenco dialed in with the Walker to allow no drift with the Timeline.

Sarcher, What is the evidence that the hum is (or was) due to the motor/cartridge interaction?

Banquo, I have some knowledge but not much skill when it comes to the electronics of either a motor controller (for BD) or a drive system for a DD tt. If I have a problem, I rely upon Bill Thalmann to deal with it, at my expense. But I do have the good fortune to live within 30 min of Bill's shop.