2. analog
  3. 1322606082

Using a DD table as motor to drive another table

I have an old Denon DP-52F turntable. After reading the thread about turntable speed, I have a newfound respect for accurate and consistent speed.

It occurs to me that I could modify my old DD Denon to drive the platter of my SME 10 table via a thread drive. I have to get out the old table to see if it has variable/adjustable speed, but could this idea work?

I could just listen to the Denon and compare it to the SME, but the cartridge, arm and wiring are all different. The SME should be the superior table in most ways, but the direct drive of the Denon has me intrigued. Has anyone tried something similar? What are the issues involved and how should I get started? If the two platters have the same diameter, the speed should be close, hence the importance of variable speed on the Denon for any minor speed adjustments. Any advice would be greatly appreciated.
peterayer
hiho
451 posts
 

It works great except it takes up a lot of table space. Do it.

_______
ths364
181 posts
 
You would just be using the DD as a belt drive in this case. I think the advantage of direct drive is that there is no slippage-in other words, the torque is sufficient to pull the record past the stylus friction for improved dynamics. Unless the SME has a very heavy platter that would act as a flywheel of sorts, I suspect the difference would be negligable. That being said, if you've got the time to monkey with it- try it!.
hiho
451 posts
 
I used VHS tape to drive a passive platter with a DD table. Make sure you use a table with speed control. Models I recommend are Technics SL-M3, SL-M2 and JVC QL-F6, all have flat rim for the VHS tape to ride on. Other models will work too and you can also try thread drive. VHS is the only interface I tried so I vouch for others. You get the speed accuracy of DD but the decoupling of the tape filters out the cogging so you get "belt" drive table with the advantage of DD minus the sterile sound. The set up is a hassle at first, I have to say... but you get to realize how poor the motor is in many belt-drive designs. If you have the table space and time, once set up it's pretty stable. I don't have the space to do a set up like that anymore but it works. Have fun.

_______
hifiharv
351 posts
 
This would be a very interesting experiment. But, think about the bearing on the DD table. It probably was never intended to take the side load imparted upon it while driving another platter by belt. Only the downforce of a balanced platter spinning. I'm doubtful that you will actually improve the sound of the SME in this way, but, it would be fun. Maybe on a lesser table, the results could be an improvement.
casey33
260 posts
 
If you google Roscoe Primrose and look on his DIY page you can see a similiar set up
More to discover