24 feet DIN to XLR phono cable for Graham Phantom?

I think Jensen Transformer make such a device. Have never tried one though. In this case you could put you TT and phono stage were you want and run XLRs to the transformer by the integrated amp. I think it would be worth a try. You may want to ask Allnic if that makes sense to do.

I have googled and found some conversion boxes that do what you suggest. With one of these boxes I could put turntable and phono pre close to each other, run a long balanced cable to the conversion box and a short RCA cable from the box to the integrated amp.

Problem is:
1- conversion boxes quality seem to be below the quality of my other components (at least if price is a good indicator of quality). I fear to decrease overall sound quality
2- I'm very happy with the sound after having located my equipment in the plane of the speakers and therefore not willing to spend much money in relocating

I must say that I have found amazing the power of collaboration of this group and the number of valid alternatives and opinions I've got!

Dear J, I may have lost track of the facts, but I thought your main issue was using very long phono cables, from your tt to your Allnic. And then I thought that you have had a good result moving the Allnic (at least) close to your tt so as to obviate the need for long cables. Once you've done that, I also believe the Allnic has balanced output, so you should be "home free", if you want then to run long cables from it to your integrated amp or linestage or whatever. You don' need no stinkin' converter boxes.

Dear L,

My first question was about feasibility of using long balanced cables to connect my arm to the phono pre. My intention was to separe the TT from the rest of the equipment, as it is the most prominent, disruptive piece within my music rack and was clearly interfering with the back wave of my electrostats. I was asuming that my phono pre had XLR inputs. Through the postings I realized that what it actually has is a XLR output but only RCA inputs (ooops!).

Your suggestion about positioning the rack right between the plane of the speakers worked so well that I considere I have solved my problem.

I cannot separate phono pre and integrated amp without using the conversion box because the amp does not have XLR inputs to match the phono pre XLR output.

I could still move the TT and phono pre away from the rest of the equipment using the conversion box mentioned in latest posting, but I'll skip it as I'm happy with what I have now.

Hope this clarifies.

I have three turntables in two systems. One of the turntables is off the main gear table in one of the systems and requires a 20' stereo phono cable from the step-up transformer to the phono preamp. Zu Mission cable proved up to the task. It's quiet and the xformer output has no trouble driving the length resulting in uncompromised, full-bodied sound.

*This would not work if the cartridge had to drive its signal through that length of cable* alone, but if you use a MC with a xformer, Zu Mission will likely suffice at 24', however you terminate it. So I suggest a normal length tonearm cable to SUT, then 20 - 24' from SUT to your electronics. If you're using a HOMC or MM cart and expect to drive 24' directly from the cartridge motor, don't.

Phil