Oracle Delphi Mk I motor and PS upgrades

Are there any good/cheaper alternatives to Origin Live's motor and PS upgrade for the Oracle Delphi Mk I?

mingles02-28-2012 9:00am

mingles OP Details Discussions Posts This discussion Message User 800 posts 03-11-2012 at 07:47am Copy Comment URL Report Comment Edit Delete I adjusted the screw on the back of the motor as far as it would go. I don't see anything to adjust on "the left side of the front speed selector mount." Your Delphi is newer than mine, so I might not have that. Thanks again for your help.
manitunc Details Discussions Posts This discussion Message User 795 posts 03-11-2012 at 12:09pm Copy Comment URL Report Comment Edit Delete Ok, then try putting a layer of tape around the part of the platter that the belt rides on. This makes the platter circumferance bigger, which would slow down the platter. YOu may have to use more than one layer. masking tape works fine, but make sure you clean and degrease the area so it sticks well.
mingles OP Details Discussions Posts This discussion Message User 800 posts 03-12-2012 at 06:31am Copy Comment URL Report Comment Edit Delete doh! that's a brilliant low cost solution. Thank you!
mingles OP Details Discussions Posts This discussion Message User 800 posts 11-27-2012 at 05:34am Copy Comment URL Report Comment Edit Delete Manitunc, this is a bit late, but I appreciate your help. I'm embarrassed to say, but I was using an LED to measure the speed. A friend clued me into the fact that an LED doesn't flicker at 60 Hz. I don't why I didn't think of this sooner, but I'm happy to report that my motor speed is spot-on without any repairs or mods.