2. analog
  3. 1331487186

Tracking force and Unipivot tonearms

I have a Benz Glider and the "recommended" tracking force is 1.8 to 2.2 grams. I am tracking at about 2.4 or 2.5 just to keep it in the grooves during hot peaks on some records. A audiophile friend told me it is not uncommon especially with unipivots to set tracking force at 10 percent or higher than the recommended tracking force. The cart sounds much more full, less sibilant and a more solid sound at the sacrifice of a less air at this heavier tracking force.

Has anyone else found it absolutely necessary to set tracking forces much higher than the recommended force? My friend said it will not damage the cartridge or records at 2.4 or 2.5 grams. He said I should not get hung up on recommended tracking force as all tonearms are different and that it is just the "recommneded" tracking force
tzh21y
stevecham
3,340 posts
 
That's pure BS. Provided you have a cartridge that has the correct compliance for use with unipivots, you should be using the manufacturer's recommended VTF. Higher forces will force misalignment of coil and magnet structures within the cartridge.
tzh21y OP
1,654 posts
 
Is this true? I would not think 2 to 3 tenths of a gram would have this affect. I could see if I was tracking a full gram over the recommended weight may be a little too heavy. I noticed some of the other Benz carts go as high as 2.5 grams. The compliance is fine for my arm
Post removed 
syntax's avatar
syntax
2,193 posts
 
I am tracking at about 2.4 or 2.5 just to keep it in the grooves during hot peaks on some records

Probably you should think about a better Playback System when this way is the only one which works well for you.
I use Graham Arms for more than 10 years now and I am always at the lower end. But I don't use rattling turntables ... :-)
More to discover