Frogman,
Thanks for clarifying. You said it simply and clearly, and without any annoying overshoot/ringing on the leading edge. ;)
Opus88,
I didn't know what halls you frequent, so thanks for clarifying. I haven't been to the Musikverein or Concertgebouw, unfortunately, but like most classical buffs I have many recordings made there. Their renowned "warmth" is quite audible in the rich harmonics and long decays, yet I don't hear any rounding at all, plenty of clean, crisp leading edges. I think we suffered a vocabulary malfunction. :)
As Frogman said, your OP did seem to be seeking a bandaid approach. It was that which I was urging against. By finding the VTA adjustment problem you actutally did what I'd recommended: identifed the source of the problem. Good job!
Doug
P.S. On any arm with a threaded VTA/SRA tower, it's advisable to make adjustments by taking the arm below where you want to end up, then move it back UP to the desired setting. This takes up the backlash in the threads and assures that the arm is actually at the setting you want. This was discussed several years ago on my "TriPlanar Tips" thread but it applies to any arm with a similar design.
Thanks for clarifying. You said it simply and clearly, and without any annoying overshoot/ringing on the leading edge. ;)
Opus88,
I didn't know what halls you frequent, so thanks for clarifying. I haven't been to the Musikverein or Concertgebouw, unfortunately, but like most classical buffs I have many recordings made there. Their renowned "warmth" is quite audible in the rich harmonics and long decays, yet I don't hear any rounding at all, plenty of clean, crisp leading edges. I think we suffered a vocabulary malfunction. :)
As Frogman said, your OP did seem to be seeking a bandaid approach. It was that which I was urging against. By finding the VTA adjustment problem you actutally did what I'd recommended: identifed the source of the problem. Good job!
Doug
P.S. On any arm with a threaded VTA/SRA tower, it's advisable to make adjustments by taking the arm below where you want to end up, then move it back UP to the desired setting. This takes up the backlash in the threads and assures that the arm is actually at the setting you want. This was discussed several years ago on my "TriPlanar Tips" thread but it applies to any arm with a similar design.