2. analog
  3. 1344464506

Setting Azimuth

Details:
VPI Scoutmaster
JMW 9 standard tonearm
Soundsmith Zephyr cartridge band new
Using a Fozgometer and Hi Fi News Test LP both also brand new
I'm measuring at the interconnects off the turntable.
I cannot seem to achieve a proper azimuth that will give even channel balance. The only adjustment on this tonearm is the counterweight which is weighted a the bottom so turning it side to side should effect azimuth. Only extreme changes are affecting channel balance. I changed the interconnects in case they were causing the problem, but I get the same results. The right channel is a few decibels louder no matter what I do to the azimuth unless I make an extreme adjustment which has the tonearm cocked to one side and obviously this is not correct.
arnold_layne
andyprice44
133 posts
 
Get the soundsmith counter intuitive. It will make your life a bit easier. It is another small weight that fits over the vpi offset counter weight. It comes with an adhesive grid that you attach to your vpi weight. Then you slide on the soundsmith weight over it. Once it is in place you can fine adjust azimuth and VTF with a grid to mark your adjustments. A VERY useful device. Check it out.

Andy
brf
1,715 posts
 
Check the offset angle of your cartridge. A misaligned cartridge will cause channel imbalance. The Mint protractor is an excellent alignment tool.
dougdeacon
3,338 posts
 
I cannot seem to achieve a proper azimuth that will give even channel balance.
Azimuth has little if any effect on channel balance (except when very badly mis-adjusted, as you've experienced). You're measuring the wrong thing.

This has been discussed many times on this forum. I suggest you search and read before further spinning your wheels whilst aimed in the wrong direction.
arnold_layne OP
141 posts
 
When I measure each channel separately with the fozgometer using tracks 4 & 5 of the hi-fi news test lp the right channel reads a stronger signal than the left channel.
dopogue
1,773 posts
 
I have a Zephyr and a Counter Intuitive on my JMW 10.5i arm and had little difficulty setting azimuth with my Fozgometer. Peter Ledermann does have reservations (which I've forgotten) about the Fozgometer, by the way.

I love this cart/arm combo but did call Peter when I was having a "low rider" situation with the stylus coming too close to the LP for comfort. What he said kinda surprised me: run the arm slightly tail-up (rather than level) and set the VTF at 1.4g, which he said would work fine with my arm, instead of the 1.8 to 2.2 range shown in the "manual" that came with the cart. This certainly did the trick as far as the low-riding was concerned.
More to discover