Cartridge for VPI Classic 3?

Captain what was your setup for the xx2 with your classic arm to get the sra you got? I have my arm base running well below level, tipped down in the back and then run a fairly high vtf of about 2.17 on my classic 1. Alignment ans setup done with a mint lp protractor. I agree it's a great combo especially now that I am running it all into my Pass XP15 phono stage. I load at 100 ohms and run the highest gain of 76 db. Into the lowest gain setting on my pre. Deep tuneful bass, smooth holographic mids and wonderful highs. I think this cart needs a fair amount of gain to get the dynamics it can deliver. It works well with a wide range of material esp rock.

I have a Benz Wood SL on my classic one and I am very happy with it.

Chuck

I'm using a Benz LPS in my 10.5i and am loving it. No inner grove distortion, great dynamic range, delicate when required, and bold when the record demands it...great depth, air....I haven't heard better.

I tried both the Lyra Delos and then the Kleos with my Classic 3 tone arm / Scoutmaster combo. I found both these cartridges to be smooth but lacking deep bass and general excitment. I've always loved Dynavectors, but did not want to go to a SUT and another set of cables (see my active thread on this one). I just tried a Soundsmith Zephyr and have to say it seems to combine the best aspects of deeper bass and an exciting presentation with the smoother high end of the Lyras. Only have 10 hrs on my Zephyr so far, but it blows away the Kleos at 1/3 the price, IMHO at this point. I can hardly wait to hear how it matures with more break-in.

I pretty much used the procedure by Michael Fremer on Analog Planet > Setup tips> How to use a USB Digital Microscope to set 92 degree Stylus Rack Angle (SRA). I used a different digital microscope (it was around $40) and is very high power, 800x. It is a little hard to use at that power, and I also needed to take off the front protective piece so I could get it close enough for the focus. I took the image, transferred it to Powerpoint, then drew my graphic lines on the image. Then I measured the angles with a protractor on the screen. I repeated the procedure, raising the VTA tower, until I achieved the desired angle, 91.5 degrees.

Every stylus is different, so my setup might not work for you. I needed to raise my VTA tower significantly to get to 91.5 degrees. What is nice, is it gets you in the ballpark and then you can fine tune by ear.

Also, make sure to check your MINTLP again, since as you raise the VTA, you will also change the geometry of the arm, and you will need to re-align on the MINTLP.
I am at 2 grams VTF and 100 ohms load right now, but still optimizing.