Where exactly do I add oil to VPI classic motor

Actusreus,
I can respect your opinion and am greatful for the suggestions. I wasn't trying to discredit you or start an argument. With regard to removing the pulley, it is quite simple to do. It is only press fit onto the shaft. The tolerance is so tight between the shaft and pulley you really can't install it wrong. As long as it sits down on the brass collar. If you do a google search on lubricating VPI motors you will see it mentioned elsewhere to remove the pulley.

I did try to do as you suggested with the syringe at first. The gap between the bottom of my pulley and motor housing was so small I couldn't even get the needle through. In my case the pulley had to be removed as others have done. It could be our tables are manufactured a bit differently. This method did solve all of my motor noise. It is dead quiet now. I also strobe checked my speed and it is correct as well.

In any case, I think we both agree that VPI should be more specific in the owners manual about this and not contribute to the confusion by only having one single sentence that says to put a drop of oil below the brass piece. In my opinion, I believe the brass collar on the shaft is the brass piece that the manual refers to. This makes sense as the shaft enters the motor directly under the brass collar. I just wanted to post my experience and what worked for me.

The pulley sits on top of the brass collar, correct? Why do you need to take off the pulley to get under the brass collar?

I have a VPI rim drive and I just pull up on the pulley to expose the motor shaft just below the brass collar and apply a drop using a needle and I am done. I don't even remove the drive belts.

Andy,

It's ok if you did it differently and ignored my advice. I simply offered what I thought and still think is the correct way to do this job. I don't take it personally as an attempt to discredit. However, the common sense, the manual, and the nature of the task all convince me that you should not be dismantling anything on your own for this purpose. You also assumed that the brass piece the manual speaks of is hidden below the pulley whereas the most plausible (and to me most sensical) answer is that it is the brass collar on top of the plinth around the pulley.

Btw, I don't even know how you removed the tiny screws from the pulley; they don't look like any screw I've seen before, and appear to require a special tool to remove them. That also tells me that this is not a user-serviceable part.

Anyway, the best way to settle this once and for all is to ask VPI directly. Hopefully, it will also prompt them to clarify this in the manual.

Again, I can't speak to specifically to the Classic, but most VPI pulley's are either pressure fitted (older tables) or held in place with a grub screw (newer tables) which requires an allen key to loosen and adjust. Nothing complicated about removing and reinstalling a VPI pulley.

Mine do not look like screws that can be removed with an allen key. If so, it'd be the smallest allen key I've yet to see. They look more like hollow bolts with tiny screws inside that require a very, very small screwdriver of some sort to unscrew them. Regardless, the question is not whether you can do it, but whether you should do it. In my opinion it's completely unnecessary.