VPI Platter Spinning SLOWLY

Why don't you just contact VPI with your issue . They have excellent customer support. They e-mailed me with an answer to my question on Sunday morning. Can't get better than that.

Chuck

I had a similar issue and found I was using too much white lithium grease.
I cleaned everything off really well and put a very small amount on the bearing. worked fine then.

Use a qtip to clean out the shaft on the platter. You can use a little 91% isopropyl alcohol. Get out all the goop all the way up into the bearing cup. Use a few more and clean the thrust next. Wipe it all down so there's no grease anywhere. Clean off the platter on the sides where the belt goes--use a little non ammonia windex to degrease.

Put a tiny dab of super lube at the top of the thrust bearing just as big around as the tip of the bearing. None on the shaft at all. Place the platter straight down and give it a turn. That's all you need to do.

Then wash the belt using a little dawn dish soap and rinse well. Dry it. Put into a ziplock and add some talcum or baby powder. Seal the bag and lightly coat the belt. Shake off the extra. Now with clean hands put the belt back on the pulley and around the platter. You are good to go for another 9-12 months. The belt won't squeak on startup either.

If your Classic is relatively new, the platter comes with a dry lubricant on it already. It may need to be lubed after a year or two. I got the Classic platter for my Superscoutmaster/rim drive, and made the mistake of putting lube on the bearing. When I got the platter into the well, it was so tight, it didn't turn at all. I contacted VPI who told me to remove the lube that I put on, clean out the well, and try again. Its running perfectly now.

Stringreen, how did the Classic platter compare to your former Super Platter?

Sorry for the slight thread derail.