RCA output on a turntable?

That is correct, but if you search the Agon classifieds you will find them listed as "phono preamp" or phono stage. I suggest look for recommendations in the archives or google.

Excellent answers by Elizabeth and the others above. I would add that "RCA" refers to a type of connector (plug and jack), not to the characteristics of the signal that is being sent through the connector. Most turntables in fact connect via RCA connectors, at the far end of a detachable or permanently connected cable. But those RCA connectors must be connected to an external phono stage if one is not included in the preamp (or in the turntable itself in a few cases).

The kinds of signals you are referring to as "RCA" are more properly referred to as "line level," as opposed to "phono level."

Also, it is important that the characteristics of the phono stage be compatible with the kind of cartridge that is being used. Most notably, moving magnet cartridges and low output moving coil cartridges have very different phono stage requirements, although some phono stages provide a choice of settings that allows them to handle either type.

Regards,
-- Al

I once had a Bang & Olufsen Beogram 3300 turntable with a built in phono section. All that was required was plugging in the captive RCA cable to a preamp input. Very convenient and surprisingly good sounding. However, while that was a feasible option, you will find very few options that offer this type of combination. On the other hand if you like your AES preamp you might want to match it up with an AES phono stage. Then add a turntable, tone arm, and cartridge to the mix.

To really address your question though, there are a combination of things that contribute to outstanding vinyl playback. The good news is you do not have to break the bank to achieve it. What type of budget would you have to pursue this project? That would be the first place to start.

So now you know you need a phono preamp aka phono stage. Check needledoctor.com for a wide variety of phono preamps. Like any other component, they will range from below $100 to five figures.

To answer your questions about turntables using RCA, they all use RCA outputs - some are hard wired and some have RCA output jacks so can use interconnects of your choosing. A decent entry level table having RCA jacks would be the Pro-ject Carbon. Stepping up to above $1000, would be the VPI Traveler. There are many, many others. Happy hunting.