2. analog
  3. 1355598927

VPI owners.......

If you have the platter that has the three leveling set screws, ( mine is the HW-19 ) here's a free and accurate way to level/true the platter. Cut a business card on a gradual slope. As you slowly glide it under the platter while spinning, you'll hear/feel the contact. It's good to mark the point at which you're adjusting with a tape dot so you'll be adjusting from the same point each time. Sit back and enjoy.
128x128slaw
don_c55
1,025 posts
 
@Slaw Balance is both the vertical and horizontal movement of the platter.

When a car tire is balanced the mechanic does not use runout.

Setting the platter by matching the dots works great, IMO, on my TNT Mk III.

I agree with Bpoletti, you are splitting hairs, no platter is perfect, horizontally or vertically.
don_c55
1,025 posts
 
@Slaw If you bought a used VPI and the previous owner screwed with the platter screws you are SOL! Better to buy new.
bpoletti
1,553 posts
 
The only platter runout problems I've ever had were associated with previous users that changed the leveling screws in the first place. (I've bought several used including my current original Aries.)

It doesn't take much to place the platter at the recommended position. That seems to result in a good runout.
frogman
7,472 posts
 
****@Slaw If you bought a used VPI and the previous owner screwed with the platter screws you are SOL! Better to buy new.****

VPI reset and balanced the set screws in my MK5 platter free of charge; didn't even charge me return shipping. Great customer service.
bpoletti
1,553 posts
 
@Frogman Did you need to send the table back or just the platter and bearing? (Just curious)
More to discover