2. analog
  3. 1357321298

Setting tonearm angle?

I recently lucked out and got a great deal on a VPI Scoutmaster 2 with JWM 9T arm and proceeded to set it up.
I had never owned a high end table like this so the set up was a bit new. My question concerns the VTA of the arm. I set it by measuring from the bottom surface of the arm to the record surface at several places along the arm to get the arm as close to level as possible.
Is that a logical thing to have done? Would the sound better if the angle was biased in one way or the other? (Dynavector DV-20X2 H cart being used) Thanks.
rmcfee
actusreus
733 posts
 
Rockitman,
Where does one get such a small bubble level? I tried to use a small (as compared to what you usually see) level attached to the tonearm tube, but it was too heavy and was compressing the cantilever way too much to make it usable.
If you know your level is 0.5 g you can easily make that adjustment with the counterweight to counteract the compression.
rockitman's avatar
rockitman
417 posts
 
I bought mine from a photo website. It is a Gitzo Tripod bubble level replacement. Here is one

http://www.outdoorphotogear.com/store/gitzo-replacement-bubble-level-for-tripods-and-leveling-bases.html

Yup, I do that added weight to compensate for the added weight of the bubble level when when using it for leveling.
actusreus
733 posts
 
Thanks for the link, Rockitman!
wolf_garcia
6,686 posts
 
I found a bubble level set on Ebay...a tiny one and a REALLY tiny one...cheap.
john_gordon
116 posts
 
Actureus

"Why would the azimuth change when you adjust the VTA? The two are set in two different planes. The SRA and overhang, sure, but not the azimuth. "

It depends on the arm design. If the bearings are at right angles to the arm tube then the cartridge will tilt as it is raised and lowered. The bearings should be at right angles to the plane of the cantilever movement.

For a unipivot, it depends on the way the weight is distributed, or if it has a device like the Graham.

John
More to discover