Lew
The K&K is the basic Moving coil transformer (about 2008 vintage) that i used to replace my Vandersteen OL-1. It is the small unit that plugs into the MM section of what was my Rotel phono stage. I had finally gotten into moving coils with a Sumiko Pearl and then a Van Den Hul Frog hi output and it sounded real crappy with the rotel MC input so a friend sold me the OL-1. I big improvement but i then purchased the K&K based on some feedback that it was quieter. It was a nice improvement over the ol-1 as it had progressively gotten noisier. I then had the opportunity to get a ZYX airy3 and the gain just was a little on the low side with my rotel so i got the zyx artisan and wow what an improvement. I think the gain was the key and i put my trusty K&K up until recently. I have ended up significantly upgrading a lot of my equipment (speakers, preamp, amp, etc) and found that once again the gain was just a little marginal. i decided then to try to improve my analog chain and got with Mehran who let me try various loaners. I wanted to compare the K&K(as well as the OL-1) through my existing Artisan MM with the various pieces of equipment. The RCM sensor was just a better fit. Not sure if the ZYX possibly had some worn components or if i just needed a little more gain with the UNIverse ll cartridget but the noise level using K&K with my old rotel or even my newer (2009 vintage) zyx artisan was higher than the RCM. I had already upgraded cables all around hoping that was the issue. However, the K&K is a good unit and i have donated to my daughter as she now is using a Moving coil (my old frog). Hope this answers your question
The K&K is the basic Moving coil transformer (about 2008 vintage) that i used to replace my Vandersteen OL-1. It is the small unit that plugs into the MM section of what was my Rotel phono stage. I had finally gotten into moving coils with a Sumiko Pearl and then a Van Den Hul Frog hi output and it sounded real crappy with the rotel MC input so a friend sold me the OL-1. I big improvement but i then purchased the K&K based on some feedback that it was quieter. It was a nice improvement over the ol-1 as it had progressively gotten noisier. I then had the opportunity to get a ZYX airy3 and the gain just was a little on the low side with my rotel so i got the zyx artisan and wow what an improvement. I think the gain was the key and i put my trusty K&K up until recently. I have ended up significantly upgrading a lot of my equipment (speakers, preamp, amp, etc) and found that once again the gain was just a little marginal. i decided then to try to improve my analog chain and got with Mehran who let me try various loaners. I wanted to compare the K&K(as well as the OL-1) through my existing Artisan MM with the various pieces of equipment. The RCM sensor was just a better fit. Not sure if the ZYX possibly had some worn components or if i just needed a little more gain with the UNIverse ll cartridget but the noise level using K&K with my old rotel or even my newer (2009 vintage) zyx artisan was higher than the RCM. I had already upgraded cables all around hoping that was the issue. However, the K&K is a good unit and i have donated to my daughter as she now is using a Moving coil (my old frog). Hope this answers your question