SUT Hum

What happens when you tie the ground of the SUT to the preamp While the phono ground is also at the same point? Still get the hum?

Thanks for all response.
I connected the ground cable from the turntable to SUT and a wire from the SUT to the phono preamp.
Then, most of the hums were gone. The level of hum was further reduced compared to the ground cable connected to the phono preamp or the preamp.

Is it normal?
Previously I had a cinemag SUT and I only connected the ground cable from the turntable to the SUT, and the hum level was very low.

Don't get this thread. Ground connected to preamp, NO hum. No problem.
I'm just say'n ✌️

I connected the ground cable from the turntable to SUT and a wire from the SUT to the phono preamp.
Then, most of the hums were gone. The level of hum was further reduced compared to the ground cable connected to the phono preamp or the preamp.

Is it normal?

Yes- that is normal.

Yes - this suggests that in your SUT the chassis is not grounded unless you connect a wire to the preamp from the earth post of the SUT. If the SUT chassis is not grounded then all the soldered connections inside are unshielded and prone to RF and this is why the noise reduces further when you connect the SUT ground to the preamp.