Why do digital cables sound different?

One more thing, the logic analyzer used actually had 1 meg memory, not 16 meg. Someone borrowed my 16 meg aquisition module.

I no longer have an analyzer, but whebn I did it was oked up to CD players and Transport / DACs. You just can't send bit patterns with your equipment because its probably far more sophisticated than what's in a CD playback system. Remember you also have to send 44,100 samples per second. A scope works fine at the output of the DAC to determine differences in the analog output of test signals. If you use the same transport, same DAC and same source, any differences must be from the cable. Also disconnect the destination end of the cable and put a volt meter on it, notice the large differences.

OOps almost forgot, in your test how did you verify that all samples sent were received and stored? If you sent 500,000 samples, did 500, samples get stored?

All I did was set up a burst of each pattern and a signature pattern (to be used in the little vbasic program I wrote) and had the pattern generator resend the the sequence over and over until I filled up the aquisition memory of the analyzer (It took some time so I did some real work also). However many samples it took to fill up the aquisition memory is how many samples I got. I did not count how many patterns I captured but it was alot! I used a Tektronix TLA704 analyzer so I stored the results on the analyzers hard disk. Tek's analyzer also runs windows so I wrote the Vbasic program right on the analyzer. I did a simple compare of the 5 bursts I sent (16 bits of all 1's, all 0's etc.) until I hit the signature burst and I started the compare over again and repeated the process until the software could not find the signature burst. If I got a situation where it did not compare I incremented a counter in my program. The counter never incremented so there were no errors. To test my software I buggered up my captured data file a bit and the program caught it. It was really an easy experiment but I probably spent more time on it than I should have at work but I trust nobody will tell my boss. As a designer of these types of systems I am sure you have run similar tests. While this is not my forte ( I do DSP design) it sounded like a valid test and you challenged me to the task.

One more thing. The rep rate of the bits in each burst was 10KHz. Ok, I should have set the rate to 40KHz, but I still doubt I would have lost any data as this is a pretty low frequency for these cables or at least 2 of the 3 cables.