How to remove harshness from my digital gear

Most of the problem is related to the CD. Stock off the shelf CDs almost always sound harsh, tinny, thin, generic, boomy, grainy, two dimensional, distorted, uninvolving, boring and metallic.

Even with an analog front end, there is such a thing as a harsh cartridge. Analog or digital, start at the very source of the sound and go from there by isolating and substituting until you have identified the harsh contribution to your sound.

Enjoy the music.

Steve at Emperical Audio:

I know I have a great deal of ground loop hum (audible from the speakers at all times). How do i get rid of it?

Geoff - the CD sounds thin due to jitter from the badly formed pits. Rip the CD with dbpoweramp to .wave file and then rewrite onto a CDROM using a good writer and you will experience lower jitter. Reclock the CD transport and you will experience even lower jitter.

IME, its easier and less expensive to go the computer audio route to achieve lower jitter than CD players.

Steve N.
Empirical Audio

Robsker - there are two things you can do to eliminate hum, short of buying different components:

1) try changing the AC power for each component. IF they are all on the same circuit, this should minimize it, but may not stop it. Different phases from the panel will definitely cause hum. Lots of separate power feeds to a single system is usually disastrous.

2) Get a transformer buffer/isolator like the Final Drive or a TVC like the Music First to replace your preamp. This will break some ground loops.

Other things that can cause hum are: direct connection of a cable TV system to your system ground. Buy a Jensen RF isolator and insert in the CATV cable to stop this. Some components just have screwy earth grounding, so hum can be impossible to eliminate on these....

Steve N.
Empirical Audio