2. cables
  3. 1124311280

Bi-wire options

i thought it would be better to post this question in a cable circle than out in the open. here are some bi-wire options that i have run across and would like to get your impressions on the sonic benefits of each.
1) cable attached to the upper posts.
2) cables attached to the lower posts.
3) keep the two neg. posts shorted and cables attached to the upper or lower posts.
4) attach the pos. cable to the upper post and the neg. cable to the lower post (diagonally)

thanks,
marvin
mboldda1
mboldda1's avatar
mboldda1 OP
575 posts
 
sorry, i meant hooking single wires to bi-wire terminals.
kr4's avatar
kr4
3,704 posts
 
"sorry, i meant hooking single wires to bi-wire terminals"

Oh.

In that case, 3 won't work.
1,2 and 4 will, so try 'em.

Kal
rockvirgo
587 posts
 
Hi Marvin. Sonically it's up to you to discover which you like best. However from one standpoint, because the low frequency drivers are going to demand the most power, I'd connect your single wire speaker cables to those first. Allow the jumpers to supply the less demanding tweeters.
yioryos's avatar
yioryos
723 posts
 
I agree with jeffreybehr and would add that some people including myself like to use identical speaker cables for both low's and high's runs to the amp.Others like to use heavier gauge on the low's and lighter gauge wiring on the high's.I personally use Analysis Oval 9's but seen Kimber Kable 8TC for low's combined with 4TC for high's that really like to try.
Best
George
mt10425
1,138 posts
 
Rockvirgo states a commonly held viewpoint. However, the maker of my speakers (Tannoy) recommends connection to the upper posts first, then jumpers to the lower posts. Stuart Marcus, owner of Vampire Wire suggests the same thing and that's how mine are are connected. Try it and see what you think.
More to discover