Synergistic New Tesla Line...Any comments?

I have a question about securing my QLS. The PCs for the CDP and Pre make it tilt on it's side and unstable in it's position. So I zip tied it to the rack so it's held solidly down flat against the wood.

But then I wondered if vibrations from the rack would negatively affect the sound.

Should I isolate it from the rack? put some footers or spikes on it and then zip tie it down?

I would like to add that I have recently moved my Hologram A power cord from my Amp to my Preamp.
I also moved the Presicion Ref power cord from the Preamp to my Amp.
I have only listened to this switch for a few hours thus far, but so far, I like what I am hearing.
Better high Frequencies and better imaging.

I also have other power cords, a T2 on my Quattro, and a Hologram D On my CD Player. Along with Apex speaker cables and interconnects and my PowerCell SE

Adwiegert, my QLS 9 is just laying on the floor. It is such a snakes nest back there that I never even thought of vibrations having and effect. But prior experiences strongly says it will. There is also the problem of the SR cables being on the floor rather than supported on isolators. I am going to see whether I can do something about this today.

Yeah I've got all my cables supported with large Cardas V-blocks. I should get some extras... then I can put the QLS on the blocks to raise it above the rack (they are taller than the racks bottom frame if stood on their end) and still strap it enough to keep it falling over while avoiding direct vibrations.

Adwiegert, well the answer is isolating the QLS was a big improvement. I only had a Walker Audio isolation platform for use under his velocitor as shown on his webpage. I basically had to lean over my system holding on to the back wall to get it into place and then to raise the QLS-9 into position. The sound stage got noticeably more open and transient attacks improved.