Synergistic New Tesla Line...Any comments?

Yeah I've got all my cables supported with large Cardas V-blocks. I should get some extras... then I can put the QLS on the blocks to raise it above the rack (they are taller than the racks bottom frame if stood on their end) and still strap it enough to keep it falling over while avoiding direct vibrations.

Adwiegert, well the answer is isolating the QLS was a big improvement. I only had a Walker Audio isolation platform for use under his velocitor as shown on his webpage. I basically had to lean over my system holding on to the back wall to get it into place and then to raise the QLS-9 into position. The sound stage got noticeably more open and transient attacks improved.

Ozzy. Let me know how that switch with your Hologram A and your Precision A turns out. I just got my Hologram A on my power amp. I have my Precision AC on my QLS9 and T2 on Pre. I can switch the three around and see what happens. I have no Powercell yet so everything is plugged into the QLS9. The Precision really works best on the QLS in my setup now until I do purchase a P. Cell 10SE. If I take it off the QLS the soundstage, dynamics & definition just collapses. On the other hand, the Hologram A is really really defined, expansive, dynamic and immersive. It is an experience worth every penny.

Regards Bacardi

i am from ,india,i have been following all the threads about tesla products,which are not available here and i just have to depend on your threads and buy the products from manufacuterers or from SE Asia as most of these are not available here,first i was planning to put up Oyaide fittings for my dedicated line for my living voice speakers and leben amp,which i have bought slowly overtime but after reading your threads i decided to go for tesla recepctacle which i shall be getting from South east Asia with wires of romex from USA and as a member suggested instead of buying Audience aR2p conditioner i will buy a powercord to replace my stock powercord of my amp and CDP,actually i wanted to buy tesla powercell6,for which there is no review,all the audigoners have reviewed powercell 10SE,which at present i cannot afford and used available on audiogon does not suit 220v input

The Powercell 6 is very similar to the Powercell 10Se. It only have 6 outlets and used 20-amp powercords. It is a little warmer and only shades below the 10SE.