Kubala Sosna and Virtual Dynamics - Similar??


I have gone through the Forums and checked on the comments and write-ups on both brands. Both are rated highly, especially for the KS Emotion and VD Master and Revelation ranges.....

I would like to know how similar these cables are in terms of sonics for Speaker cables and Power cords...

It seems that VD is hugely popular at the moment and KS is used by a select few....

Where I am, there is no dealer available, therefore I have to rely on your comments and suggestions...KS doesnt allow international trials and have not checked with VD..

Similar Products used:
Kimber BiFocal XL
DIY PC's with Furutech Gold IEC's
Running dedicated 32 amp lines

TIA!!
teck5
Thanks Ozzy...

Sounds like you have gone through quite a bit to get synergy...from your set up..

To give you an inkling....I tested IC's Kimber KS 1030, AZ Siler Ref 2, AZ Matrix Ref 2, Cardas Golden Reference and a couple of others...

I ended up putting the Cardas Golden Reference between the Pre and Power amp...It gave a good tonal accuracy but is a little thick....I balanced this out by putting the AZ Silver Ref 2 between the Source and the Pre...

So this is kind of a benchmark for me...for IC's

For Power cords...I have a Hydra 8 linked to a 32 amp dedicated line...using a DIY Furutech cable (with their components)....I noticed that when I put all the equipment through the Hydra 8....The soundstage grew wider and the music became more controlled (blacker)....

However, I found that I had to bump up the volume anywhere from 3 db to 8 db to get the same effect if not using the Hydra 8...In short, it sounded a little veiled...

I did try the Hydra 8 with the Taipan Helix and Python Helix....Again...the smoothness of the sound is definitely there but this drop in db kind of bothered me...can't explain but did not like the sound....

Now I run my amps direct and the source and the pre through the Hydra 8...Sounds a little better...meanwhile I have ordered a Running Springs Audio Duke to test which will come next week...

So my point now is that with the investment to be made for power cords....well I would like to be sure and not take a leap of faith...in the case of these two brands, there are no dealers here....and so comments and sharing of experiences is important for me...

Thanks again
Teck
I have 3 dedicated outlets .
2-20Amp for my Digital and Analog and a 30 Amp for my Pass Labs Amp.
Amps lose some of the dyanmics when plugged into a conditioner, including the Hydra 8 and the Hydra 2.
Thats why Power cords are so imporatant on Amps too!.
Just run them straight into the wall with a good oulet. (I use The Wattgate 381)

Different cords match better with different equipment.

Generally, the better cords on Amps are ususally heavy gauge.
I really liked the Shunyata Annaconda, but prefer the Purist Anniversary. I was never impressed with the other Shunyata Power cords or for that matter there speaker cables.
HI Ozzy,

Thanks for the advice....time for me to go test with other cables that are available to me...

Teck
Ozzy. Did you have the Machina dynamica Brilliant Pebbles in your system when you had the Kubala cables??
Maybe that was the problem and you didn’t have a impedance mismatch or something after all, you could have just needed the Pebbles in your system.