bi wiring

I can only add that I am confused that speaker cable companies would take the time and effort to produce cables that employ different metalurgy and guages of wire in one cable run, if they didn't believe it could make a difference in frequency and time delivery. Jason, I can only suggest that since you have raised the question, that you should experiment with bi-wiring. As mentioned in my original post some people do hear a differnce while some don't. Again it all depends on your ears, and system. There is no right or wrong for everyone. So far you have heard from someone who does and one who doesn't hear a difference. Some speaker manufacturers add bi-wireable connections and others don't. An one last point here Jason, is you never mentioned your speakers or amplification? I wish to add that I am just answering your thread and don't intend to debate the subject. These thougts occurred after my first response. Hope it helps.

I am confused that speaker cable companies would take the time and effort to produce cables that employ different metalurgy and guages of wire in one cable run, if they didn't believe it could make a difference in frequency and time delivery

??? Theo, the propagation "time" differences would be below experimental limits of measurement... electrons run fast -- at close the speed of light in fact (that's faster than a Ferrari). WHy would people produce these? Maybe because it's a product likely to be purchased... As to gauge, you could try very thin wire that would typically favour transfer of higher frequencies vs.. thicker cable that would favour lower frequencies.

Two cables (biwiring) reduce the possibility of intermodulation...

The easiest is to try! Cheers

Anyone who asks Why biwire? will eventually get the response: I've yet to hear a reasonable explanation how it could be advantageous. When that explanation is supplied - biwiring isolates the current passing to the different drivers and allows you to select gauges especially suited for each run - you'll hear that the advantages aren't really advantageous and it's all marketing and nonsense. You've already gotten the best advice - try it. Then rest easy knowing you've exploited the full potential of your speakers.

some speakers sound better biwired.
Example: most of the B&Ws, some Vandersteen.

For other speakers it may not matter.

There are different types of bi-wire speaker cables.
Shotgun bi-wire speaker cables - 2 separate runs to speakers, but terminated into a single run on the amp end so you don't have to use 2 sets of binding posts.
Example of this cable is Acoustic Zen Satori Shotgun.

Internal bi-wire cables - terminated as a single run on the amp end, internally biwired with 2 pairs of leads for the speaker end.
Example of this cable is Acoustic Zen HologramII, the biwired version.

Then you can always use 2 totally separate speaker cables if you have 2 sets of binding posts on your amp.

Will your speakers benefit from one config over another?
The only way to find out is to try.

Hey Jason, Dont worry about Jeff he is Bi-Polar hehehehe