2. cables
  3. 1181919608

Why are there no high end cheater plugs?

Yes, I know there are safety reasons for not using such ground lifting devices; but as many audio magazines have suggested, the benefits from lifting all grounds except the preamp are quite substantial. But the 79 cent cheater plug covers much of the improvement. I made some cheater plugs using silver wire but Eagle plugs. They are better than the grey guys. Why does no one make a quality plug? I understand that at one time Siltech did make such a plug.

Please no "educate" me of the safety reasons for not using cheater plugs. I think the success that our immediate ancestors had in surviving two plug ac, suggest that chassis shorts must be quite rare.
tbg
butsy
23 posts
 
Buy a high quality 3 prong plug but don't connect the ground lead!(for safety reasons I discourage this)
undertow
1,033 posts
 
Well if your using a cable that has the simple WBT type casing you just open the casing up with a screwdriver, and disconnect the ground in the power cable itself.. I have done this in the past, then put it back later if needed.. however if you need to cut off heatshrink or something to get in there, well it would need to be replaced, or left off till you go further with it. I would never use a cheater plug on a good cable, simply cause of effecting the already good connection and plug.. Not for saftey reasons though. I mean hacksawing off the ground, leave it, and just cut off any heat shrink keeping you from disconnecting the cable the proper way internally.
unsound
7,329 posts
 
Manufactures know there's no money in it.
"Cheaters never prosper".
tbg OP
5,263 posts
 
Undertow, as I told Porter, one cannot get inside the plugs on Stealth Dream cables. They are glued on.
rx8man's avatar
rx8man
1,481 posts
 
Albert,

I'm with you on this one. I recently installed a 10-2 dedicated line to my second room upstairs.

Rather than try to figure out which component IEC to dismantle, plug to tear apart or cheater,
I figured how simple it was to drop the ground wire inside the dedicated duplex box which my Hydra is plugged.

Everything in my rig is floated and it sounds better than it ever has.

I live in a "slightly AC polluted" condo complex and God only knows the miserable wiring installation (Federal Pacific boxes) they used during construction (late 70s) wasn't anywhere near top notch (cheap bastards)
More to discover