Why are there no high end cheater plugs?

Rex, please don't assume that I am doing this purely on a logic of my own. There is little question that having the grounds wires are a more safe condition than not having them. It also would be yet safer to have no electricity in your home. Please reread my initial post and remember that I asked only about the availability of quality cheater plugs. My posting to which you refer was in response to Carl109 trying to educate me.

I don't agree that Mr. Whitlock is not ignoring the points that I have made, but it is, of course, your life as it is mine. I think the odds of anything happening within a component that does not cause the breaker to trip and for anyone to touch the unit and provide a ground, is considerable lower than driving your car to work and having a fatal accident. I never said anything about "without risk", you did.

Thank you for the insincere wishes of good luck.

Albert, I did float the preamp also tonight just to see if there was further improvement. You are right. The dynamics, clarity, and ambient information are further improved. In the past, I had done all of this and also minimized ac volt leakage with the orientation of the ac plug. But this time the impact seems far greater.

I am thinking about trying one of these diode devices. Until the voltage on the ground get up to nearly one volt, there is no ground.

http://www.ebtechaudio.com/humxdes.html

Glad floating the preamp helped you, my system will not work with grounds connected, all I get is hum. Oddly enough the one time the system did not hum with grounded cords, the preamp was floated inside by design and the amps were Atma-Sphere MA2's which are also floated by the manufacturer during assembly.

I can't swear that's the situation this minute, but it's laughable to have a grounded cord on these pieces when they're disconnected inside. This falls into the same category of a single ended amp that sports XLR connectors. Quite often you open them up and there's a wire soldered from the XLR over to the RCA.

Truly balanced and truly grounded? Not :^).

The link you provided is interesting. That's the first I've heard of that product. It looks flimsy, not audiophile grade but looks can be deceiving.

I hope it does not sound like those surge suppressors that are supposed to help audio gear. All of them I've auditioned were terrible, even on very low amperage devices.

Albert, it is basically two diodes that only provide a ground at nearly one volt, below that there is no ground. As I would be using it, it would just provide safety, which so concerns some. It amounts to a cheater plug.

Hi,

There are adapters that will allow you to use a high end cable on a cheater plug or a cloverleaf plug. See dedicated audio website and click on adaptors.

www.dedicatedaudio.com.